Diversey Restroom Floor&Surface Disinfectant (101105992)

For General Use:

• For use on hard, nonporous inanimate environmental surfaces such as floors, walls, glazed porcelain, glazed ceramic tile, plastic surfaces, shower stalls, bathtubs and cabinets.
• To disinfect inanimate, hard nonporous surfaces, dilute according to label directions.
• Apply solution with a mop, cloth, sponge or hand-pump trigger sprayer so as to wet all surfaces thoroughly.
• Allow to remain wet for 10 minutes then remove excess liquid.
• For heavily soiled areas, a pre-cleaning step is required. Prepare a fresh solution for each use.

For J-Fill® Use:

• Insert cartridge into dispenser (see J-FILL® dispenser instructions for proper cartridge placement). Fill small bottle or bucket or use gun to apply a foam directly onto surfaces to be cleaned, scrubbing with a soft brush, pad or cloth. Do not allow foam to dry. Rinse surfaces thoroughly. NOTE: Some commercial strength cleaners are unsuitable for use on some surfaces. Test in an inconspicuous area prior to use.

For RTD® Use:

• Fill trigger spray bottle with product. Apply to surfaces to be cleaned.
• Wipe with clean cloth or towel to dry. Dilute with cold water.
• To avoid food contamination after cleaning, sanitize and rinse all food contact surfaces with potable water before reuse.

For Command CenterTM/MC Use:

• Command CenterTM/MC: Attach bottle to Command CenterTM/MC Dispensing System and fill ready to use chemical by actuating touch point (reference Command Center dispenser instructions). Connect hose to cold water tap.